By default, the Z axis rises to 1" when Stop is pressed

[a.werby]

Unfortunately, I don't actually have that much headroom on this particular project, so it triggers a fault, and I can't resume smoothly. Where do I change that 1" value to something lower, like .25"? It doesn't seem to be in any of the places I looked for it.

[scottp55]

Type VC in command line (Values Cutter) change Safe-Z to whatever you want(I JUST finished a project that needed .01")
ALSO make sure in the Vectric file Safe Z1 and 2, AND the HOME position are set accordingly.
scott

[a.werby]

Thanks, Scott - there had to be a way!