New Life for Salvaged Corian [Archive]

View Full Version : New Life for Salvaged Corian

Ken Sully

11-19-2019, 08:49 AM

Had a neighbor redoing his kitchen. He replaced the Corian counter tops and I got a few pieces. One of those someday projects. One came up and I gave it a try. Carves very nice and already had a finish on it. I filled the carving with DAP tub and tile filler which supported some of the fine cuts and was quite easy....fill it in wipe off with sponge and water.

Sorry about image being off, not sure why it did that.

Jerry Carney

11-19-2019, 09:51 AM

What bits did you use , And what depth did you cut, how many passes ?? Nice project

scottp55

11-19-2019, 09:56 AM

Nice "salvage job" Ken!! :)
scott

Ken Sully

11-19-2019, 05:23 PM

33386

I used .0625 end mill .5 in/sec 9 passes to a depth of .25 on the fish.Go fish same. Bar and grill carve .25 depth

scottp55

11-19-2019, 07:22 PM

MUCH better pic Ken!
Well done!! :)
scott