paul60
02-13-2020, 02:20 PM
running Mach3
few days ago moving x axis using key board arrow keys.
x will only move in one direction makes no difference what x axis arrow i use.
shutting down andstarting up correct the problem.
but it keep coming back.
running a file today machine made a sudden stop x started moving in the opposite direction about an inch then corrected itself.
any ideas?
thanks
few days ago moving x axis using key board arrow keys.
x will only move in one direction makes no difference what x axis arrow i use.
shutting down andstarting up correct the problem.
but it keep coming back.
running a file today machine made a sudden stop x started moving in the opposite direction about an inch then corrected itself.
any ideas?
thanks