Change in speed value (VS) need defaults back

[tracys]

While in move/jog mode a pop up window appeared stating something had changed. I kind of ignored it since I didn't change anything. Then as I went to move in XY I appeared to not want to move although the coordinates were changing slightly. After cutting power to the control box and rebooting, same problem. I started over trying to move the gantry in move mode, still nothing. After closer inspection the gantry was moving, just very slowly. Z always moved correctly. After trying to remember what the pop up window said, I went into the values and see what I could find. I found the XY move speed is 0.05. This does not seem correct. Does anyone or have values that I can change these back to, or a default setting. Attached is a screen shot of the current values.http://www.talkshopbot.com/forum/attachment.php?attachmentid=34204&stc=1

[scottp55]

Probably higher for your machine, but here are the Desktop's Default VS settings.
You should probably just do a UR and reset to your machine's defaults, or your custom setting if you have one saved.
scott

[tracys]

Thanks Scott, thats what I was looking for.

[scottp55]

I've had something like that happen twice(changing settings) and read somewhere to shut down SB3 first, then computer, then machine.
Been following that routine 5 yrs now and hasn't happened once since I started doing it in that order.
Maybe happened to you?
Sudden power outages I've heard can do it too.
Glad it helped! :)
scott