kra
10-08-2025, 05:36 PM
ShopBot PRS Standard CNC Router
4’x8’ table with new MDF spoil board installed
HSD spindle
Uses ER35 collets (1/2” collet included)
Spindle wrenches included
Z-zero touch plate included
Machine set up to run on 220-240 volt single phase
Spindle runs on 3 phase controlled by VFD which is controlled by ShopBot
Everything works as it should
I can demonstrate it running
I can lift with overhead chain hoists to load onto a flatbed trailer
A nice ShopBot for the price
Located in Sanford, NC
27332
4’x8’ table with new MDF spoil board installed
HSD spindle
Uses ER35 collets (1/2” collet included)
Spindle wrenches included
Z-zero touch plate included
Machine set up to run on 220-240 volt single phase
Spindle runs on 3 phase controlled by VFD which is controlled by ShopBot
Everything works as it should
I can demonstrate it running
I can lift with overhead chain hoists to load onto a flatbed trailer
A nice ShopBot for the price
Located in Sanford, NC
27332