No movement on PRT, figuring out unit values

[gisigns]

I am setting up my, new to me, ShopBot. Of course, I have made several changes. The old windows 98 computer was missing files and it could not find any part files, so I installed SB on a newer computer running windows ME and upgraded the control box, and SB to version 2.39.
Everything appears fine but I can't get the machine to move or cut. I disconnected all the motors and pushed each axis to make sure there was no binding. I reconnected everything and rebooted. I can here the motors attempting to move it but nothing happens. I also need to input my unit values from the old computer but it shows a lot of numbers that are not labeled. I think I have an x and y value but don't see a z value.
Thanks
Heather

[myxpykalix]

Call Shopbot direct, they can give you the specific values you need to input. It sounds like that might be the problem.

[jerry_stanek]

Make sure you are in the move cut mode and not the preview mode. That drove me crazy trying to figure it out.