woodman
06-19-2006, 05:41 PM
We recently picked up a ShopBot PRT and when I set it to lead in so as to not mark the pieces, it began exhibiting an odd issue with the corners at the lead in points.
I've attached a .dxf illustration of what is happening. The piece should be a rectangle, but at the very corner, there's a roughly 1/16th indentation which isn't really acceptable. Is there a way to get rid of that?
3830 (23.0 k)
I've attached a .dxf illustration of what is happening. The piece should be a rectangle, but at the very corner, there's a roughly 1/16th indentation which isn't really acceptable. Is there a way to get rid of that?
3830 (23.0 k)