View Full Version : Problem with drawing....

02-02-2006, 04:58 PM
I have a PR with 2.20 drivers and am trying to put an engraving of a tiger (2d) in a piece of wood. I am using Enroute3 to do the picture. The thing is that when i put the commands into the shopbot it only draws circles and lines. I think it might be outdated drivers or the enroute coding. Any suggestions would help. THX

Big Willy (Unregistered Guest)
02-02-2006, 09:13 PM
you have to convert to shopbot code...or update your post processor...I think shopbot has a post for enroute on the website under downloads