Block Load Pull-up Disabled

[groover@americanwoodsign.com]

I have looked for hours through the Command Reference Manual and I cannot find instruction to enable z axis pull-up during file block load. My 'bot used to do it but not since I installed the new software.
Anybody remember where to turn it back on?

Hugh Mahlendorf
American Wood Sign Co.

[Ted Hall, ShopBot Tools]

Hi Hugh,

It's the last parameter of [VC]. Use the current Command Reference which is easiest to access by just hitting [HC] when you're in the ShopBot Software. Put a 1 in for the last VC parameter and that will restore things to the way you want them. (Your change will be saved in the ShopBot.ini file, so you won't have to worry about changing it again.).