Driver/Motor Fault Location

[toe_jam (Unregistered Guest)]

After an hour and a half of straight use, this message pops up all of a sudden and stops the machine. "Driver/Motor Fault Location". I have to reset the box then resume, the location is off a 1/16" of an inch but resumes. It ended up coming up about 2 more times. On the keyboard the input 4 is flashing.

Any Ideas?

[egastelum@westcoastsignco.com]

I called SB and one of the reps had mentioned it could be due to my prox wires running along with my motor cables or noise in the power & possible not grounded dust collector. I don't know if it's the prox wires as this all of a sudden happened but I did check the 6" hose as it goes into the dust collector and it was clogged up with very little going thru. It's grounded, but can this cause the problem?

[evan]

Make sure the table, the X and the Y gantries are grounded. You can do a search on the forum concerning grounding, it's been discussed before.