View Full Version : Shopbot Firmware Installation - BAD TRANSMISSION

04-19-2006, 06:09 PM
You may want to try again...

System seems to be hooked up and responding, there may be a transmission problem..

Here is how my day is going. My old control computer quit transferring files.. I was burning them to disk and then bringing them out.. knew it was bound to happen.. anyhow, I am working on installing the new computer that I have had, but had not had a chance to install.. I am going from a USB drive to the serial port...

I installed the new control software.. and it asked me to install the new firmware.. and this is what I get for listening to it..

I need some help guys.. my machine is dead in the water.. can I go back to an old firmware.. or please oh please tell me what steps I need to do in order to get back up and running..


Frustrated Stick..

04-20-2006, 12:23 AM
Everytime I do a firmware update, I have to change my com port setting. It's different from the default.

04-20-2006, 12:50 AM
This post (http://www.talkshopbot.com/forum/show.cgi?tpc=26&post=22597#POST22597) may trigger some thoughts.