Reg (Unregistered Guest)
12-29-2005, 12:30 AM
Hello Fellow CNCers..
Is there a way to adjust the ruler zero location for both the X/Y axis in AC? Being able to set guidelines helps, but it would be rather handy to set the zero point of the rule to an arbitrary location rather than just center or the lower left corner.
I'll be the first to admit that I may be missing something... The Missus remindes me of that all tooooo often.
Thanks mates,
Reg
Is there a way to adjust the ruler zero location for both the X/Y axis in AC? Being able to set guidelines helps, but it would be rather handy to set the zero point of the rule to an arbitrary location rather than just center or the lower left corner.
I'll be the first to admit that I may be missing something... The Missus remindes me of that all tooooo often.
Thanks mates,
Reg