Partworks pp mm-arch end statement missing

[dingenis]

my pp shopbot arc_mm. generates files that will allways give the warning C# 91 because there is a end statement missing (allways runs into the subroutine unit error
any suggestions,(i could not modify this pp ).
thanks

dingenis

[bill.young]

Have you downloaded the updated PartWorks postprocessors from the ShopBot website? If so and you're still having problems, email support and they'll get it fixed ASAP.

http://www.shopbottools.com/drivers.htm

Bill

[dingenis]

thanks bill,
i just had not seen this update,
it's fixed.


dingenis