Duct Collector

[dubliner]

Sorry the picture sucks but I took the impellor housing off a Jet DC1100 & mounted it above the table, removed the 2x4" inlets & replaced with 1x6" It works very well & allows me to walk all around the table. Just need to make some sturdy brackets to mount to the ceiling now & get a long ranger ac switch. FYI Sch. 40 3" flange fits perfectly inside a 4" flex hose & the thin part of pipe fits the Shopbot dust hose like it was made for it.

396


397


398

[jeffreymcgrew]

Never took a picture of it, but our dust collector tube is setup in a similar fashion. I.e. hung from the ceiling. We've got ours zip-tied halfway up the wire support, and then from there a slack loop up to a ceiling mount that then runs hard tube back to the dust collector.

It works well (so far).