View Full Version : Trim Tool

09-11-2008, 04:10 PM
Okay...this is driving me nuts!!! Does PartWorks have a trim tool like PartWizard has? I see the cut tool, but this does me no good. I just would like to trim off some lines!!!!

09-11-2008, 04:21 PM
No trim tool. Zoom in, create a node using the node tool, then you can delete the excess segment. I understand a trim tool may be in the future, but alas not now.


09-11-2008, 04:29 PM
Thanks! Just figured I'd try the node tool...which makes me crosseyed after a bit!!!!

09-11-2008, 07:11 PM
keep zooming in (G) It gets around some of vcarve limitations.