What are good bits to use when v-carving Aluminum and Brass?

[jeffreymcgrew]

Hey all, we're getting into some signmaking for a client where we'll need to do some fine engraving of brass plates, and some v-carving of aluminum and brass for a nice beveled edge. I've just been running test cuts with standard solid carbide 90 and 60 degree bits that are meant for wood and/or plastic. It works, but it does wear the point of the bits down some. Anyone know of a supplier that carries v-bits that are made for carving metal instead?

[garyb]

For fine engraving of aluminum/brass
Onsrud, tip size .005 through to .090 on V60° same tip sizes for the V30° 1/4" shanks & 2" OAL
You can look them up part #'s 37-00 series and 37-20 series most run $18.30 ea or $128 for the set

[jeffreymcgrew]

Gary, thanks! I saw those bits after I posted here, but it's great to hear that they are the way to go. We've had good luck with Onsrud's aluminum cutting up spirals in the past.

[Brady Watson]

Jeff,
For engraving AL & brass I use Micro100 brand engraving tools. The ones I use have .005" knocked off the tip. http://www.micro100.com/

5088

If you are going to v-carve AL or you just need a good strong robust bit for bevelling, a mill/drill is hard to beat. It is solid carbide & ground to EXACTLY 90 or 120° depending on what your needs are. They are not cheap, but they go the distance.

5089