Zeroing Speed

[wberminio]

I need to slow down my Z when I zero my drill.
I can't remember how to do it
Can any one help me out?



Thanks

Erminio

[Gary Campbell]

Erminio...
Are you zeroing or setting the offset? If setting the drill at zero, then in the C:\SbParts\Zzero.sbp file, somewhere around line 70 (if you are using a newer version of the software) you will find the speed lines:

'Save current speeds and set zeroing speed
&start_Zmove_Speed = %(73)
&new_Zmove_Speed = .25

Set the StartZmove speed to your preference (Try around .5 to 1) and the last pass at .25 should be OK.

If using the drilloffset file, then find the speed lines in that file and do the same.
Gary

[wberminio]

Thanks Gary

I'm zeroing the drill bit.
I just couldn't remember where to do it.

It's been one of those "days"


Erminio