bill.young
03-09-2010, 07:50 AM
I just got an email from Tools Today about an Amana trimmer bit with a 1/4" shank but with a smaller 3/16" cutting diameter and bearing.
http://www.toolstoday.com/p-6125-flush-trim-with-miniature-ball-bearing-guide.aspx
Looks like it could be handy for ShopBotters that cut with a 1/4" bit and use tabs to hold their parts in the sheet...the 3/16" cutting diameter won't bind in the 1/4" kerf and burn the way a standard laminate bit will.
Bill
http://www.toolstoday.com/p-6125-flush-trim-with-miniature-ball-bearing-guide.aspx
Looks like it could be handy for ShopBotters that cut with a 1/4" bit and use tabs to hold their parts in the sheet...the 3/16" cutting diameter won't bind in the 1/4" kerf and burn the way a standard laminate bit will.
Bill