shovel3d
11-27-2008, 01:49 PM
Are there any old PR cable sys.
I've had one for about three months now an I hope to get it up and running next weekend.
I'd like to here from anyone that has one.
I did'nt get the control set up with it. I'm going with the G540 Gecko drive. I'd like to know about control setup. With the wires that I have the to 2 X axes motor's are on the same wires, which ment that the two x axes motor's run off of one driver? I'd like to know is this the way they use to do it. I've got the VEXTA
PK 266-02A motor's an I was told that the motor's are to small for this machine. OK give me some insite on this. Thanks Tom
I've had one for about three months now an I hope to get it up and running next weekend.
I'd like to here from anyone that has one.
I did'nt get the control set up with it. I'm going with the G540 Gecko drive. I'd like to know about control setup. With the wires that I have the to 2 X axes motor's are on the same wires, which ment that the two x axes motor's run off of one driver? I'd like to know is this the way they use to do it. I've got the VEXTA
PK 266-02A motor's an I was told that the motor's are to small for this machine. OK give me some insite on this. Thanks Tom