Carving Grain in Signfoam

[David Iannone]

I want to try to carve grain into Signfoam on the shopbot. I have artcam Insignia. I figure If I upgrade to Artcam Pro I could do it in 3D, but very time consuming. Is the 3D software the only way people are doing it, or is anyone out there perfected it with Insignia or partwizard?

[paco]

VETRIC's V Carve PRO texturing toolpath strategie.

[mikejohn]

Read this (http://www.talkshopbot.com/forum/show.cgi?tpc=2&post=35506#POST35506)

[David Iannone]

Paco, and Mike, thanks a million, I downloaded the demo, and after 3 hours of playing with it am sure this is what I am looking for. I am buying it online and will be test carving grain all weekend in the garage. I'll tell the wife it's your fault, hahaha.
Thanks,
Dave