View Full Version : Plunge cut into MDO
cartar929
12-02-2009, 11:38 AM
I am looking for a high quality 1/4" bit to do plunge cuts through MDO. I currently run Gerber's wood bit, but I feel the cut could be better. Anyone have any suggestions?
blackhawk
12-02-2009, 01:49 PM
Carter - Try www.centuriontools.com (http://www.centuriontools.com)
They are in Richmond which should be real close to you.
myxpykalix
12-02-2009, 02:31 PM
actually in louisa, va but should be no more than a day away via ups unless you want to take a ride then you can come and see a few of us in this neck of the woods.
cartar929
12-02-2009, 02:43 PM
I'm actually in the Goochland Industrial Park, so not too far away really. I'm going have to see what that is all about, thanks.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.