PDA

View Full Version : 5MM DRILL BIT 1/4" SHANK


woodworx
11-12-2009, 07:36 PM
ANYONE KNOW IF THIS IS OUT THERE?
woodworx
11-12-2009, 07:38 PM
oh, one detail. Has to have over 1.25" capabilites.
Gary Campbell
11-12-2009, 07:39 PM
Justin...
5mm endmill 1/4" shank? Yes many places www.centuriontools.com (http://www.centuriontools.com) is the one I use. Drill bit... not to my knowledge.
Gary
woodworx
11-12-2009, 07:51 PM
I have the endmill. it only has 1" depth capabilites. I have some drilling that needs to go all the way through to avoid flip ops.
Gary Campbell
11-12-2009, 08:14 PM
Justin...
Sorry... you didnt post those specs. Dont have a source for that one. I would use a 5mm boring bit. Takes a 10mm collet in the spindle. 5K rpm
Gary
woodworx
11-12-2009, 11:13 PM
I will end up using a new ER-32 collet that is sized for a 5mm shank from McMaster Carr. I can then just buy a 5mm drill bit.