Table limit violation

[kern]

I am a brand new newbie with a Buddy. Using the keyboard command, I move the Y axis as far as it would go i.e. 46.0. And it stopped. Now I can't get it to move backward by the keyboard method or by the command [MY]-3. The error massage I get is "Y axis is beyond table limits" or Table limit violation" How do I get it back so that I can take command of it again?

[myxpykalix]

did you try resetting the control box (push blue button)

[jerry_stanek]

Jack what blue button?

[dlcw]

Jerry,

New or used Buddy?

If new, you should have a control box that has three buttons on it. I green one to start the spindle/router, a blue one to reset the controller and a big red one to hit when the world is about to come to an end and you want to stop it.

The blue one will reset everything and you should be able to move the table.

Don

[jerry_stanek]

I see I have a PR and a PRS standard no blue button.

[myxpykalix]

Does your unit have a big silver control box? If so on the side of it you should have 2 buttons. Mine is a prt alpha.
One button is a reset button
one button is to start my router

I'm sure everyone regardless of model should have at least the one reset button.

[jerry_stanek]

No my unit doesn't have a reset. Only the Alphas do. And no I do not have a big silver control box.