bill_lumley
09-12-2009, 09:37 PM
I am trying to rebuild my Control PC due to some problems I had with the Air Drill on the E-cabinets link and I am stuck getting past installing 3.6.5 . I am on Vista if that helps . After I load it and update the controller firmware I run the Shopbot setup routine to setup my variables . I then go into keyboard mode and move the gantry some distance in X & Y . I then do a Jog Home and it does not come back to 0,0 but comes a fraction of the way back and then resets 0,0 to some new location in the middle of the X & Y plane . Any ideas appreciated . It would appear that my unit vaules did not get set correctly .
Thanks Bill
Thanks Bill