View Full Version : Spindle RPM Display
nat_wheatley
08-24-2009, 08:33 PM
How do I get this feature out of 'Preview' Mode?
Thanks.
knight_toolworks
08-25-2009, 12:45 AM
click on the display and change the port number. it will pop up a window to change it to also look and see what number it is. also change it to 1 so it starts when you start the software.
nat_wheatley
08-25-2009, 06:30 AM
Thanks Steve, I'll give that a try today.
3d_danny
08-25-2009, 07:17 AM
Do you have the optional RPM controller installed in the VFD?
nat_wheatley
08-25-2009, 07:35 AM
Not sure if I do or not. How would I know if I do?
wberminio
08-25-2009, 07:46 AM
Nat
You would have to purchase a separate control card for this feature.
Erminio
nat_wheatley
08-25-2009, 07:58 AM
Thanks Erminio.
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.