Mahogany Cap rails

[bob_dodd]

These two booths have a inside dia. of 12 foot each. using 5/4 X 11.25" mahogany , most segments are about 35 inch long, a couple are shorter , the 3 center pcs. are 42" long. The lay out/measurement was done, by placing a string across the three ends ot the 2 booths & measure the radius of each one. Will post more pictures
849
850
851
852
853

[scottcox]

Bob,

That looks like quite the project. Please post some pictures of the finished project when you're done.

[gene]

Is this in an Atlanta Bread Co Store

[bob_dodd]

Scott Should have more pictures this week, This job was done on a BT 32 (slightly modified), great machine , not 1 joint had to be recut , took to job site all numbered , glue joints & then assembled

Gene No this is in North Jersey (Discover The East) to open june 1

[bob_dodd]

854
855
856
857
858
859
Got a chance to take more pictures today, The DXF file shows how I did the lay out, the rectangles = the size of material + the radius of curve that would fit on board , also what would fit in BT 32 The straight lines are where the joints are , I used a 3/8" 2 Flute bit @ 3 IPS with .25 step down