Home made zero plate

[brian]

How does one change the values to compensated for a home made zero plate?Mine must be thinner as after zeroing the z axis the bit still goes below the table surface
Brian

[kerrazy]

Mic your new plate, and then go into your My Variables folder, if you have the new software and cahnge your thickness there. or locate your z_zero routine file and open it up in notepad and cahnge what is possbly, .131 or .121 to your new thickness.
Dale

[kerrazy]

if you are running 3.4.19 the latest you will find a my varibales file C:\SbParts\Custom if you loaded your shopbot software on drive C:
Dale

[paco]

I would recommend the same as Dale, but you could use the ShopBot setup too (TS command). Just don't change the other values that are there...

[kerrazy]

Paco,
Call me I'm still at the shop.
Dale