Pacman cabinet

[dubliner]

Would anyone have a Pacman cabinet file. I'm working one up , but its not scaled correctly, and Ive never seen one in parts. Just curious if someone could save me a few hundred steps. TIA Dubliner

[john_l]

Neville, I have done a few different arcades but not a Pacman/Ms Pacman yet.

Two things that may help you... A measured reference can be found here http://www.retro.co.za/arcade/cabinet.html
and also, I am told that Galaga is the same cabinet as Pacman.

Also, scroll down that page and there is a .dxf file.

Good luck!

[dubliner]

Bump - anyone got some designs?? John L thanks for that, the dxf shows a good profile, but I guess I 'll have to see a real cabinet to see how they go together.

[widgetworks_unlimited]

I made one a long time ago by hand. It was too heavy/big to take with me when I last moved - too bad.

I actually went into an arcade armed with a tape measure and took the measurements right off the machine. It sounds bold, but with all the noise and action no one seemed to notice. Could workout for you too...

[robredick]

Try to give Pinball Medic in Austin a shout. If they can not help you, they might point you in the right direction.

I fixed one once. It was dado'd & glued particle board with rubber knock in edgebanding and vinyl overlay.

[john_l]

Neville,

Check your email. Maybe that will help.