Er collet holder for Porter Cable

[carlcnc]

Just used one of my PC 31/4 routers ,as I was changing collet I remembered that the collet "holder" on the motor is removeable, which means a guy could get an ER25 straight shank holder with 1.25 shank[80$] and then have it cut,bored and threaded to replace the stock
part.
Voila! er collets on your PC router!
duh, why didn't I think of this years ago??
Carl

[geometree]

why not get a dozen and sell them to your fellow shopbotters?

[carlcnc]

Shawn
I am not into marketing,
I may do one for myself,to put in my inverted router table and then post the results.
for cnc I switched to hi freq spindles years ago.
for those interested best source I have seen is USshoptools.com. look for "er" extensions.
Carl