Newbie

[plastics]

ok i know this is annoying, and im sure that the solutions is beyond simple. i am just trying to get my bot to go to x2 y15 before and after it runs a part file so it does not run into my work. the 0x,0y are at the bottom left corner and it keeps going there when i run a file...PLEASE HELP and HAVE PATIENCE.

[curtiss]

On the material setup on the "toolpath side,"
change your home position as desired, and then
recalulate the toolpaths.

[erik_f]

If your work isn't too tall adjust your safe z height so it clears your part.

[blackhawk]

You can also use the Shopbot editor to edit an existing .sbp file. Just edit both start and finish positions from 0,0 to 2, 15.

Like Eric said, I always like to set the safe Z so that it always clears your part regardless. I learned this lesson on a Bridgeport CNC milling machine. I tried to send a 3/4" endmill to home position, problem was that there was a 2" thick Kurt vise jaw in the way. It was not a pleasant sound to hear.