For CPP users

[carlcnc]

I am helping a guy setup his CPP, never used it myself.
problem is the back set of 5mm holes for KV8400 slides is not correct. doesn't match the slides.
should be 480mm[18.89inches] from the front holes. but CPP makes em 529mm[20.83inches]
Is there some setting or way to tweak this?
thanks
Carl

[Ryan Patterson]

You can adjust the location of the back holes in the drawer settings.
Go to Cabinet settings the click the button for Drawer Holes. On the Drawer holes window click the button to Add Drawer Brand this will open the drawer Guides window. On the window select the drawer brand from the drop down list. Make the corrections and then click Add Brand button. The sizes need to be entered from the shortest length to the longest and are from the front edge of the cabinet to the center of the back hole.

I hope this helps if you have any questions you can email me at info@cabinetpartspro.com

[cabnet636]

i would contact ryan at info@cabinetpartspro.com (mailto:info@cabinetpartspro.com)

what version do you have? in ver 8.5.1this can be done

yes this can de done in cabinetsettings/ drawerholes/ add drawerbrand

jim

[cabnet636]

ryan beat me to it!!!

[carlcnc]

Ryan,James

thanks, I can't get to it today. I don't have your software and the guy I am helping lives 50 mi away. He is new to cnc so throw in teaching him about setting up post processors etc mean I have to be there and show him on his puter .
plus I am new to CPP[ did play with the demo couple years ago] its been a challenge!
not sure but I think he has the latest version.

Carl