Could I get some help converting this Sketchup file?

[knight_toolworks]

here it is. if you have the dimensions that would be good. thanks so much. a dxf is fine or a vcarve file or whatever is easier.
http://dl.getdropbox.com/u/1939753/darren%27s%20baluster.skp

[mitch_prest]

here ya go

just change the unk to dxf




8903 (38.3 k)

[mitch_prest]

this may be better.. when I looked at the skp model it was in perspective mode.. dxf looked a little off.. here is a crv


8904 (13.3 k)

[knight_toolworks]

thanks so much. this should do it. I need to play more software to convert things.