'rotationtest
'File created: Monday January 22 2018 - 11:59 PM
'From Vectric
'
'SHOPBOT FILE IN INCHES
IF %(25)=1 THEN GOTO UNIT_ERROR	'check to see software is set to standard
C#,90				 	'Lookup offset values
'
TR,14000,1
'
'
'Turning router ON
SO,1,1
PAUSE 2
'
'Toolpath Name = refpoint locations
'Tool Name   = End Mill (0.25 inch)
MS,2.99,1.00
JZ,1.200000
J2,0.000000,0.000000
J3,0.000000,0.000000,0.200000
M3,0.000000,0.000000,0.000000
J3,0.000000,0.000000,0.200000
J3,-2.000000,16.000000,0.200000
M3,-2.000000,16.000000,0.000000
J3,-2.000000,16.000000,0.200000
'Toolpath Name = Profile 1
'Tool Name   = End Mill (0.25 inch)
'----------------------------------------------------------------
'----------------------------------------------------------------
TR,14000,1
MS,2.99,1.00
J3,0.000000,0.000000,1.200000
J3,1.877318,4.500473,0.200000
M3,1.877318,4.500473,-0.250000
M3,-0.483367,-6.355464,-0.250000
M3,-2.569144,-6.355464,-0.250000
M3,-0.156069,7.168983,-0.250000
M3,-4.089314,20.429636,-0.250000
M3,-2.843016,20.429636,-0.250000
M3,1.877318,10.542215,-0.250000
M3,1.877318,4.500473,-0.250000
M3,1.877318,4.500473,-0.500000
M3,-0.483367,-6.355464,-0.500000
M3,-2.569144,-6.355464,-0.500000
M3,-0.156069,7.168983,-0.500000
M3,-4.089314,20.429636,-0.500000
M3,-2.843016,20.429636,-0.500000
M3,1.877318,10.542215,-0.500000
M3,1.877318,4.500473,-0.500000
M3,1.877318,4.500473,-0.750000
M3,-0.483367,-6.355464,-0.750000
M3,-2.569144,-6.355464,-0.750000
M3,-0.156069,7.168983,-0.750000
M3,-4.089314,20.429636,-0.750000
M3,-2.843016,20.429636,-0.750000
M3,1.877318,10.542215,-0.750000
M3,1.877318,4.500473,-0.750000
J3,1.877318,4.500473,0.200000
JZ,1.200000
J2,0.000000,0.000000

'Turning router OFF
SO,1,0
END
UNIT_ERROR:
C#,91					'Run file explaining unit error
END