I have a BT32 PRS shopbot I need to sell, I have had the V Carve software upgraded to V 8.0 and will be able to transfer it to whoever buys the machine. I have a laptop computer that runs the machine just fine with all the software loaded you need. I was going to use this when I retired, I learned everything to run and cut with it, I even went to Shop Bots school in NC for a week and saw what the machines can do. I doubt this machine has over 100 hours run time on it, my loss actually. I got cancer and have not been able to do most of the things I would need to do to run and produce with this machine. The machine is located near Branson MO and you have to pick it up and load it yourself, I have a place where you will be able to load it into the back of a pickup truck without lifting. It still will require 2 people from whoever buys it, I can provide one more, but we will be able to roll it right out of the shop and into the back of a pickup. I have whatever we need to make that happen, we will have to move some things (tools) and put them back after we get it out of the shop. Maybe 2 hours tops.
Let me know what you are thinking. Oh I will give you all the bots, collets, computer, software, cables and everything you need to run. $7,500, with the software and tools over $11,500 invested. So no crying please. It is what I day so there should be no problems.
My email address wrdick@suddenlink.net , I will answer in the evenings.
I can/will post pictures later.
