Will a raspberry pi running FabMo control a PRT V4g board?
Thanks.
Printable View
Will a raspberry pi running FabMo control a PRT V4g board?
Thanks.
Check this thread:
https://handibot.com/forum/read.php?2,3607
They have posted Pi instructions:
https://github.com/FabMo/FabMo-Engin...raspberry-pi-3
I've tried those a few times and I got close, but I could never get it to work.
You do need to have a motion control board connected for it to boot, and even then I wasn't able to get it going. I'm not that great of a developer though.
It looks like they might have it working in Docker if you check their GitHub, although there aren't instructions. If Docker could work, it would be a lot easier to setup and deploy it.