If you go to the folder where all the post processors are and copy/paste the one(s) you want into the "my postp" folder, then those will be the only ones that show up in the drop box.
Printable View
If you go to the folder where all the post processors are and copy/paste the one(s) you want into the "my postp" folder, then those will be the only ones that show up in the drop box.
More good info! Thank you!
Just a quick note that I am up and running. With your help I didn’t give up. Not 100% sure I am using the correct SB file, but it works. Made a separate post about a weird noise when cutting v carve lettering.
Aspire and VCarve Pro, directly from Vectric, work fine on my 2009 PRSAlpha.
http://www.talkshopbot.com/forum/att...id=35230&stc=1I have a Shopbot PRT, with a 4g Board, circa 2006. Works great. This is the PP I use. I have Aspire but that should make any difference.
Phil