Search:

Type: Posts; User: racerboy

Search: Search took 0.01 seconds.

  1. Replies
    3
    Views
    781

    Thanks for the help, well appreciated.

    Thanks for the help, well appreciated.
  2. Replies
    3
    Views
    781

    Corian Seam Clamping Pessure

    Would anyone know how much clamping pressure is enough when joining a Corian seam together without squeezing all the adhesive out? The Corian fabrication manual specifically says to not over clamp or...
  3. Thread: corian seams

    by racerboy
    Replies
    4
    Views
    719

    Thanks Tom, but how do you get the edge of the...

    Thanks Tom, but how do you get the edge of the two pieces flush with each other when it is upside down?
  4. Thread: corian seams

    by racerboy
    Replies
    4
    Views
    719

    corian seams

    I am fabricating my first Corian countertops. I have read the Corian fabrication manual. But it does not say if the seaming is done good side up or upside down. I am thinking it should be done good...
  5. Replies
    3
    Views
    757

    So do I need all three bits to do this edge?

    So do I need all three
    bits to do this edge?
  6. Replies
    3
    Views
    757

    Corian Edge Profile

    I'm fabricating my first countertop and am trying to duplicate the Corian edge in the attached picture. I have looked for a router bit that matches the profile but unable to find anything. Does...
Results 1 to 6 of 6