Search:

Type: Posts; User: Scott216

Search: Search took 0.00 seconds.

  1. Replies
    7
    Views
    1,048

    Thanks, I'll do that

    Thanks, I'll do that
  2. Replies
    7
    Views
    1,048

    I took a closer look at the shopbot and it turns...

    I took a closer look at the shopbot and it turns out the pinon gear on the y-motor was a little loose. I tightening the set screws and it's working MUCH better now.
  3. Replies
    7
    Views
    1,048

    I did grab the spindle and gantry and try to move...

    I did grab the spindle and gantry and try to move them to see if there was any play, I didn't notice anything, but I'll do it again. I have noticed a difference between climb and conv cutting. ...
  4. Replies
    7
    Views
    1,048

    Hole not round

    On the Shopbot (PRSalpha 96-48) at my makerspace, I'm getting holes that are not round. The picture below is about 1.5" diameter. I cut it with a 3/8" end mill. Any suggestions as to what's...
Results 1 to 4 of 4