Flip ops?

[Gary Campbell]

I did a number of 90 deg rotated flip ops on Sat. I noticed the dados cut climb, instead of conventional as selected. Anyone else have that problem? I also had a label printing error, but may be my doing.

Also, there may be a new version in the future. Anyone have any errors that have not been reported?

[chunkstyle]

I have an extra tool path on my perimeter and pocket cuts. Increases my cutting time quite a bit.
Blind dado tenons have been milled without the shoulders cut on some roll out tray bottoms.
I have recently talked with TWD over a part editor issue involving a drilling operation for a 5mm hole and the machine wanting to use a .253" diameter bit.
The files have been sent to TWD. It might be helpfull to post about it here in case anyone else is seeing the same thing.

Tim