HDU, butterboard and PVC board supplier, Atlanta

[harryball]

I'm looking for a supplier in Atlanta, the south side would be nice. I need low volumes... like a sheet or two. I plan to make carvings and/or molds.

Robert

[andyb]

Robert,
Here are some suppliers in and around Atlanta. I've purchased from Aluma-panel.

Andy B.


ALUMA-PANEL, INC.
2410 Oak Street West
Cumming, Georgia 30041
(770) 889-3996
www.alumapanel.com

Sign Supply USA
3939 Royal Drive, NW, Suite 135
Kennesaw, GA. 30144
Phone: (678) 354-0788
www.signsupplyusa.com

Reece Supply Company of Georgia, Inc
5755 Oakbrook Pkwy
Norcross, GA 30093
(770) 326-7920
www.reecesupply.com

[mjindustry]

Hi guys! I'm also looking for a supplier of HDU. I've looked for months for a place that might sell this stuff in small sheets, like 2'x4' or even 4'x4' over the internet. Something that can be shipped via UPS or the like. I have nothing local or I would look there..

I've found plenty of places that will sell me a pallet or semi load over the internet...hahah I just want a few decent chunks of it. I was even so desperate I tried pouring my own substrates and it turned out pretty cruddy.

[mjindustry]

Actually, Andy your link to signsupplyusa shows that they are willing to sell the smaller sizes!

Now the only problem is the price of it!

[jamesgilliam]

Jason, Try Laird Plastics, their site shows a location in MN. Not sure if they will do smaller pieces from that location, but the one I use will sell and sometimes give me drops from other jobs they do of different materials and HDU. James

[mjindustry]

Excelletn! Thank you James. That stuff can be hard to track down. We could probably get by with the scraps that some big outfits toss in the trash...such a shame!