motorcycle club plaque

[Brian Harnett]

A lot of this was done on the bot all the 2d work I then textured and did the 3d work with my die grinders, the bit in the Makita is a solid carbide bit made for cutting fiberglass, they are great in wood and last along time, they are like drawing with a pencil.

The wood was milled with my alaskan chainsaw mill.

[bobmoore]

Looks real good Brian. What kind of wood and how thick did you make it?
Bob

[Brian Harnett]

The wood is white pine its about 1 1/2 thick at the thickest point.

I put it in my kiln before it was machined. It will be inside so eliment damage will not be an issue.