Results 1 to 2 of 2

Thread: Shopbots ER25 Collet in Autodesk F360's CAM tool library

  1. #1
    Join Date
    Mar 2016
    Location
    Silicon Valley
    Posts
    28

    Talking Shopbots ER25 Collet in Autodesk F360's CAM tool library

    So I'm learning AutoDesk Fusion 360's Tool Library and wanted to know if anyone bothers defining their collet tool holder and locknut. Is the purpose of defining tool holders for those ones that extrude further out of the spindle than a collet?

    Here are the steps I'm following:

    Fusion 360 >CAM >Manage >Tool Library >

    I choose my Local Library > New Library (or cloud if you've turned it on in preferences).

    I then select + New Holder and then enter the following 3 entries for Height, Upper Diameter and Lower Diameter:
    1 - 5mm, 21mm, 26mm
    2 - 4mm, 22mm, 22mm
    3 - 26mm, 25.5mm, 19.09mm

    The visual then looks like a ER 25 Collet.

    CAM Tool Library.jpg

  2. #2
    Join Date
    May 2015
    Location
    Rochester, NY
    Posts
    34

    Default

    So the only benefit of defining tool holding is for gouge-checking and collisions. Having your tool holding accurate in the software is crucial for 4 + 5 axis operations, but for 3 axis its easy enough to wing it. If your cutting very deep where the collet needs to go below the top of stock plane its good to know you wont have a collision. If you have the tool holder programed it's just adding another safeguard.

    Without multi-axis or an ATC setup both tool length and tool holder can just be considered when you set your tool in the collet manually. If your tool length is not exact to what you've programed then the tool holding dedicated in the software doesn't matter at all.

    My two cents
    -Byron

Similar Threads

  1. Tool Library for ShopBot Bits
    By Riptide369 in forum Autodesk Fusion 360
    Replies: 8
    Last Post: 12-20-2017, 06:01 PM
  2. 3/4" ER25 collets available
    By Ajcoholic in forum ShopBotter Message Board
    Replies: 1
    Last Post: 05-19-2014, 10:19 AM
  3. fan type collet nuts for the ER25?
    By Ajcoholic in forum ShopBotter Message Board
    Replies: 0
    Last Post: 01-25-2014, 02:07 PM
  4. ER 20 Collet Tool Holders for MRT Automatic Tool Changer
    By havery in forum Product/Supplier List and Requests
    Replies: 0
    Last Post: 03-13-2009, 10:59 AM
  5. Er25 collets in inch size
    By gabepari in forum Archives2008
    Replies: 13
    Last Post: 01-12-2008, 08:08 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •