FabMo & Raspberry Pi on a V4g control board

[Jimmy Walker]

Will a raspberry pi running FabMo control a PRT V4g board?

Thanks.

[EricSchimel]

Check this thread:

https://handibot.com/forum/read.php?2,3607

They have posted Pi instructions:

https://github.com/FabMo/FabMo-Engin...raspberry-pi-3

I've tried those a few times and I got close, but I could never get it to work.

You do need to have a motion control board connected for it to boot, and even then I wasn't able to get it going. I'm not that great of a developer though.

It looks like they might have it working in Docker if you check their GitHub, although there aren't instructions. If Docker could work, it would be a lot easier to setup and deploy it.