Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Cutting PVC Edge Finish Help

  1. #11
    Join Date
    May 2014
    Location
    MA
    Posts
    574

    Default

    The Centroid upgrade I did resulted in better quality cuts on my HDPE. It's likely because that controller is much smoother. However it's not magic.. It's not going to help account for a sloppy worn out machine, or hardware that's just not as tight/has as much mass as a beefier machine.

  2. #12
    Join Date
    Dec 2000
    Location
    Thorp, WI
    Posts
    2,775

    Default

    Yep, agreed!

    "It’s easier to fool everyone than it is to convince them they've been fooled" - Mark Twain





Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •