X and Y do Not stop Immediately

[bob_dray]

After moving either x or y axis, they move slightly before completely stopping, even if the E stop is used. They should be halting.

Motors are Vexta PK299-01AA
Software version is 3.6.44

Let me know any info addition info needed to help

[Brady Watson]

Bob,
It could be a number of things...Here's what I would check:

1) Save your configuration via US command.
2) Reinstall the firmware via UI command.
3) Check the 3 voltages: 5 vdc, 12vc via ATX power supply. Check 44v on Meanwell stepper power supply.
4) Tell us how your tool is connected to the PC - EXACTLY. To elaborate, are you using from PC to the tool: USB 2.0 self-powered hub -- USB cable less than 12' long -- IOGear USB to Serial Converter -- Control Card ~~ OR a different configuration?
5) Please try another keyboard and see if that changes anything. Are you running a wireless KB or one with a cord?

At first 'glance' it sounds to me like a communication issue, which can cause a lag between keyboard and controls...but a number of things can cause what you mention.

[bob_dray]

Brady, Thanks for your response. Having some issues with a leaky roof at the moment. I will get back to you soon. Thanks again.

[bob_dray]

Just got back to it, may have plugged into a bad USB port its working fine now. Thank you for your response!

[Brady Watson]

Very good. Thanks for following up.