2018 PRS Alpha 2021 ATC upgrade - 4x8

[samuelh2003]

This CNC was purchased originally in 2009 as PRS Standard but October 2018 was upgraded to an Alpha, all new electronics, motors and control box, later in November 2021 we upgrade to ATC with new HSD 5hp spindle, it has less than 300 hours since we upgrade to Alpha. It has a 6 zone with 6 220v vacuums connected directly underneath the plenum. I'm including the Colombo 2.5 hp spindle and Delta VFD-B drive, It comes with V-Carve Pro (never registered).
Located in West Palm Beach, Florida.
Asking $21.000

[partspeddler]

Did you have a hard time wiring the new control box in place of the old box?