Results 1 to 2 of 2

Thread: Repeating files offset subroutine

  1. #1
    Join Date
    Mar 2004
    Location
    Delray Beach, FL
    Posts
    3,708

    Default Repeating files offset subroutine

    It has been so long since I have needed to do this that the system has apparently changed.
    Lets say that I have a file that I want to run first from table 0,0 and then from 3,0 and then from 6,0. The way that it was done many moons ago isn't working and I have not been able to get it to work in preview. The object file is being created in Artcam and I removed the commands such as go back to 0,0, SO,s etc. but it still insists in not running correctly. Can someone post the subroutine file for the example above or similar that I can adapt to my genuine needs? Thanks

    Dave

  2. #2
    Join Date
    Mar 2004
    Location
    Delray Beach, FL
    Posts
    3,708

    Default

    Never mind-I just got it!!

Similar Threads

  1. Repeating toolpath
    By kubotaman in forum ShopBotter Message Board
    Replies: 6
    Last Post: 05-16-2016, 06:45 PM
  2. ATC SubRoutine modification
    By BrandanS in forum ShopBotter Message Board
    Replies: 1
    Last Post: 12-15-2014, 12:37 PM
  3. Repeating cutting path with offset
    By asteude in forum ShopBot Control Software v3
    Replies: 8
    Last Post: 01-10-2013, 08:13 PM
  4. Help with a repeating Grapevine
    By kurt_rose in forum ShopBotter Message Board
    Replies: 3
    Last Post: 12-25-2011, 04:25 PM
  5. Replies: 16
    Last Post: 06-29-2007, 01:17 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •