my pp shopbot arc_mm. generates files that will allways give the warning C# 91 because there is a end statement missing (allways runs into the subroutine unit error
any suggestions,(i could not modify this pp ).
thanks
dingenis
my pp shopbot arc_mm. generates files that will allways give the warning C# 91 because there is a end statement missing (allways runs into the subroutine unit error
any suggestions,(i could not modify this pp ).
thanks
dingenis
Have you downloaded the updated PartWorks postprocessors from the ShopBot website? If so and you're still having problems, email support and they'll get it fixed ASAP.
http://www.shopbottools.com/drivers.htm
Bill
thanks bill,
i just had not seen this update,
it's fixed.
dingenis