Corbels

[loriny]

Does anyone have any suggestions to help me get started. I am just bidding a fireplace job now and would need to build my corbels on the Bot. They will be 36-38" tall 9 1/2 inches wide and 7 or 8 deep. Any advice would be appreciated.(oh yeah, they are walnut so off the shelf won't work) I have aspire software. Or do I just need to figure out how to extrude?
Thank you
Lorin

[bob_s]

Lorin
here is a tutorial from the Vectric board
http://www.vectric.com/forum/viewtop...p;hilit=corbel
I haven't cut any using this yet, but it is similar to some other parts I have made and looks pretty straightforward for a complex part.
Just remember that you can lay a design onto the shape, so layout your shape first, then add the embellishments.
Bob