Finished Today

[joe]

19' Isoceles Triange ready for customer pick-up.


45280.jpg
45281.jpg


45282.jpg

[lstovall]

Absolutely Stunning!!

[JohnG]

Sorry to dig up an old thread, but......

Found this one, and wanted to hear more about the fabrication of this triangle.

Very nice Joe.

[joe]

John, it's easy work except for the size.

The frame was angle iron with DiBond background. I hoppered the surface with acrylic texture. To make sure the letters had a good base to set on, I placed a mask down for a smooth clean surface. The letters and tree were routed from Extira and sprayed with Sculpt Nouveau Copper. It was shipped to Frisco Texas.

One technical note.

I was very concerned there would be cracks with the DiBond seames. I epoxied supports in those area's of concern.

Thanks for the question.

J

[joe]

John,

I was wandering how you found this old post. It prompted me to see some of the posts of the past but couldn't find any photo's. I know I've put lots of them on the forum over the years. Just wondering where they are?

I'd appreciate your assistance.

Joe